OSPF technology serial 21: OSPF virtual link, a powerful tool for logical connection in modern networks!

Hello, this is the Network Technology Alliance site. In large-scale network architectures, many routing protocols have been developed to achieve efficient data transmission and routing management. Open Shortest Path First (OSPF) is an Interior Gateway Protocol (IGP) that is widely used in enterprise networks and Internet Service Provider (ISP) networks. This article will focus on […]

ospf irregular area division, database table, LSA optimization, ospf extended configuration

Hua subdirectory ospf irregular area 1. Non-backbone areas away from the backbone 2. Discontinuous backbone Irregular area solutions 1.tunnel-point-to-point GRE 2.ospf virtual link 3. Multi-process bidirectional re-publishing (recommended) ospf database table Common types in ospf database Optimize ospf’s LSA and reduce the amount of LSA updates 1. Manual aggregation—–Reduce LSAs in the backbone area 1. […]

OSPF+MSTP+VRRP+DHCP networking experiment

Experimental requirements: pc1-pc4 requires obtaining the dhcp specified ip from r4 sw1-sw4 uses mstp + vrrp protocol to achieve load sharing ar1-ar2-s1-s2 uses ospf to implement three-layer communication ar4 is set as dhcp server s1-s2 acts as a relay for the dhcp server SW1 <sw1>display current-configuration # sysname sw1 # undo info-center enable # vlan […]

A preliminary understanding of the general content of OSPF (Lesson 3)

1 Classification of routes Directly Connected Route refers to a route that directly connects two adjacent network devices in the network topology, also called a direct route. If two devices belong to the same IP network address, then they are directly connected devices. The direct routing table refers to a table generated by the computer […]

HCIP-Link State Routing Protocol OSPF (2)

OSPF routers in the same area have completely consistent LSDBs. Within the area, OSPF uses the SPF algorithm to complete route calculations. As the network scale continues to expand, routers consume more and more memory and CPU resources to complete routing calculations. Zone division can alleviate the pressure on routers to a certain extent. In […]

HCIP-Link State Routing Protocol OSPF (1)

Foreword: Routers forward packets according to routing tables, and routing table entries can be generated through manual configuration and dynamic routing protocols. Static routing uses less bandwidth than dynamic routing and does not occupy CPU resources to calculate and analyze routing updates. When the network structure is relatively simple, you only need to configure static […]

[HCIP] ensp–ospf experiment 2

Experimental requirements Experiment topology and IP address planning Basic configuration R1 [r1]interface g0/0/0 [r1-GigabitEthernet0/0/0]ip address 172.16.32.129 255.255.255.128 [r1] interface LoopBack 0 [r1-LoopBack0]ip address 172.16.33.1 255.255.255.128 [r1] ospf [r1-ospf-1] area 0.0.0.1 network 172.16.32.129 0.0.0.0 network 172.16.33.1 0.0.0.0 stub R2 [r2]interface g0/0/0 [r2-GigabitEthernet0/0/0]ip address 172.16.32.130 255.255.255.128 [r2] interface LoopBack 0 [r2-LoopBack0]ip address 172.16.34.1 255.255.255.128 [r2] ospf [r2-ospf-1] […]